Removing and installing rear door side airbag - AR91.60-P-0692M

MODEL 220 

Fig 1: Identifying Rear Door Side Airbag Remove/Install Components - Model 220

	Removal, installation
	Injury hazard  when testing or repairing airbags or emergency tensioning retractors	Store airbags with opening surface pointing up, do not expose to temperatures above 100 °C. Interrupt electric circuit when working on these units	AS91.00-Z-0001-01A
	Important instructions for performing repair, body work and welding on vehicles with airbags and emergency tensioning retractors		AH91.00-P-0002-01M
	Evaluation of airbags and emergency tensioning retractors on accident vehicles		AH91.00-P-0006-01B
	Legal regulations on handling and storing airbags and emergency tensioning retractors		AH91.00-P-0004-01A
1	Remove ignition key
2	Remove door liner on rear doors	Installation:  Replace door liner center section with side airbag triggered	AR72.12-P-1010M
3	Disconnect connector on left and right rear side airbag squibs (R12/11 or R12/12)	Installation:  Connector should catch audibly
4	Drill out rivets (1) on side airbag retaining plate (3)	Installation:  For mounting use rivet, part no. 003 990 24 97
5	Remove side airbag	Disposal:  When side airbag is replaced dispose of defective part properly. ↓
	Instructions on disposal of airbags and emergency tensioning retractors		OS91.00-P-0001-01A
	Render airbag unusable		AR91.60-P-0611A
6	Install in opposite order
7	Perform diagnosis	Star diagnosis