Remove front seat backrest cover - AR91.18-P-1820M
Models 220.0 /1
Shown with front seat backrest removed
Fig 1: Identifying Front Seat Backrest Cover Remove/Install Components - Shown With Front Seat Backrest Removed (1 Of 3)
Shown with front seat backrest removed
Fig 2: Identifying Front Seat Backrest Cover Remove/Install Components - Shown With Front Seat Backrest Removed (2 Of 3)
Fig 3: Identifying Front Seat Backrest Cover Remove/Install Components - Shown With Front Seat Backrest Removed (3 Of 3)
| Remove | |||
| 1 | Remove head restraint guide on front seat | AR91.16-P-0050M | |
| 2.1 | Remove front seat backrest (1) | up to 31.8.02. |
AR91.10-P-1060M |
| 2.2 | Remove driver's seat cushion | As of 1.9.02. | AR91.10-P-1070MB |
| 3 | Pull covering (2) out of the insert fold (arrows) on the bottom of the backrest frame (3) | ||
| 4 | Pull out shackle of rubberized fiber matting (4) at bottom (arrows) on backrest frame (3) | ||
| 5 | Unhook covering (2) all-round at the backrest frame (3) (arrows) | ||
| 6.1 | Disconnect connector for backrest ventilation | With front deluxe seat, incl. heated seat and seat ventilation, code 401a. | |
| 7 | Remove covering (2) with rubberized fiber matting (4) from the backrest frame (3) | ||
| 8 | Remove side stapling clips (5) from the stapling wires (7) | ||
| 9 | Release stapling clips (6), to do so rotate staple clip through 90° using flat pliers | ||
| 10 | Pull the Velcro fabric strips off the rubberized fiber matting (4) | ||
| 11 | Pull covering (2) off the rubberized fiber matting (4) and remove | ||
| Install | |||
| 12 | Insert stapling clips (6) into rubberized fiber matting (4) and straighten out | ||
| 13 | Pull covering (2) at the top over the "head" of the rubberized fiber matting (4) | ||
| 14 | Fold upholstery (2) to side, place on rubberized fiber matting (4) and straighten out | ||
| 15 | Connect longitudinal stapling wires with the stapling clips (6) | ||
| Installation tool for retaining wire | WF58.50-P-9118-02A | ||
| 16 | Align covering (2) with the rubberized fiber matting (4) and fix in position at the side with Velcro fabric strips | ||
| 17 | Hook side stapling clips (5) into the stapling wires (7) | ||
| Installation tool for retaining wire | WF58.50-P-9118-02A | ||
| 18 | Insert backrest frame (3) into rubberized fiber matting (4) | ||
| 19 | Slide shackle of rubberized fiber matting (4) (arrow) at bottom into backrest frame (3) | ||
| 20 | Insert covering (2) all way round on backrest frame (3) and at "header piece" | ||
| 21 | Install rear restraint guide on the front seat | AR91.16-P-0050M | |
| 22.1 | Install front seat backrest | up to 31.8.02. | AR91.10-P-1060M |
| 22.2 | Install driver seat cushion | As of 1.9.02. | AR91.10-P-1070MB |