Removing and installing front power seat motor group (seat cushion) - AR91.29-P-1420N

MODEL 215 

Fig 1: Identifying Front Power Seat Motor Group (Seat Cushion) Remove/Install Components - Model 215

	Removal, installation
1	Remove front seat	Lay front seat on suitable and clean subsurface	AR91.10-P-1000N
2	Remove left/right convenience adjustment control modules (N31/N32)		AR91.29-P-1550N
3	Remove seat cushion		AR91.10-P-1070N
4	Unscrew screws (1) from forward/back motor (M27m1/1, M28m1/1), from rear raise/lower motor (M27m2/M28m2) and front raise/lower motor (M27m3/M28m3)		Figure
		Unscrew inner Torx screws only from defective motor	*BA91.29-P-1001-01A
5	Remove seat forward/back motor (M27m1/1, M28m1/1) and rear raise/lower motor (M27m2/M28m2) and front raise/lower motor (M27m3/M28m3) from seat adjustment device	Replace only defective motors
6	Install in opposite order	Installation:  Ensure that cables are routed properly
7	Check seat adjustment for proper function

SEAT ADJUSTMENT

Number	Designation		Model 215
BA91.29-P-1001-01A	Screw for motor seat adjustment	Nm	5

Fig 2: Identifying Torx Bit Set (000 589 01 10 00)