Remove/install engine mount - AR22.10-P-1100IW

ENGINE 112.975, 113.948 /966 in MODEL 220 

Shown on engine 113, right engine mount 

Fig 1: Identifying Engine Mount Remove/Install Components - Shown On Engine 113, Right Engine Mount

Shown on engine 113, right engine mount 

Fig 2: Identifying Engine Mount Remove/Install Components - Shown On Engine 113, Right Engine Mount

	Removing
1	Remove engine suction fan ducts (1) in front of air filter
2	Remove engine front cover (2) in front of air filter
3	Detach engine support frame		AR01.10-P-7500-03I
4	Remove top engine mount (3) from engine support (4)
5	Lift engine a little
	Risk of death  caused by vehicle slipping or toppling off of the lifting platform.	Align vehicle between columns of vehicle lift and position four support plates at vehicle lift support points specified by vehicle manufacturer.	AS00.00-Z-0010-01A
6	Raise vehicle
7	Remove lower engine compartment paneling		AR61.20-P-1105M
8	Remove front drive shafts		AR33.30-P-0620I
9	Remove engine mount (3) below from front axle carrier (5)
10	Lift left steering knuckle at supporting joint using assembly and transmission platform as far as necessary, until the left engine mount between suspension strut and tie rod can be taken out toward rear	When removing left engine mount. Observe the environmental protection regulations for the disposal of engine mounts. Dispose engine mounts into mixed scrap.
11	Guide right engine mount (3) to inner front across the front axle carrier (5) and take out toward top between radiator and engine	When removing right engine mount (3). The engine must be raised sufficiently so that the engine mount (3) can be passed between the engine and front axle carrier (5). Observe the environmental protection regulations for the disposal of engine mounts. Dispose engine mounts into mixed scrap.
	Install
	Notes on self-locking nuts and bolts		AH00.00-N-0001-01A
12	Mount top engine mount (3) on engine support (4)	The anti-twist lock (a) on the engine mount (3) must be seated in the retaining groove (b) in the engine support (4).
			*BA22.10-P-1004-01L
13	Lower engine
14	Mount bottom engine mount (3) on front axle carrier (5)	The engine mount (3) must be seated in the elevations on the front axle carrier (5).
			*BA22.10-P-1001-01L
15	Install front axle shafts		AR33.30-P-0620I
16	Install lower engine compartment paneling		AR61.20-P-1105M
17	Dismount engine support frame
18	Mount cover at front end of engine (2) in front of the air filter
19	Install engine suction fan ducts (1) in front of air filter

ENGINE MOUNTS, ENGINE SUPPORTS