| |
Install/remove |
|
|
 |
Risk of death
caused by vehicle slipping or toppling off of the lifting platform. |
Align vehicle between the columns of the lifting platform and position the four support plates below the lifting platform support points specified by the vehicle manufacturer. |
AS00.00-Z-0010-01A |
 |
The 
lifting platform safety devices (01) must always be installed in pairs, i.e. at two locations of the vehicle's longitudinal members. The two
lifting platform safety devices (01) can optionally be installed either both at the front, or both at the rear, or both on the same side. |
|
Fig 2 |
| 1 |
Unscrew plastic bolts (2) of the lifting platform supports (1) |
|
|
| 2 |
Lever lifting platform supports (1) out of longitudinal members |
Do not use any sharp edged tools to avoid damage to the longitudinal member. |
|
| 3 |
Insert lifting platform safety into the longitudinal members devices (01) |
|
Fig 2 |
| 4 |
Swivel levers (01a) of
lifting platform safety devices (01) to the right |
This will lock the
lifting platform safety devices to the longitudinal members. |
|
| 5 |
Adjust support plates (4) of the lifting platform support arms (3) to the height of the
lifting platform safety devices (01), or to the height of the remaining lifting platform supports (1), respectively |
Rotate support plates until they contact the
lifting platform safety devices or the lifting platform supports at the longitudinal members, respectively. |
|
| 6 |
Raise vehicle with lifting platform |
|
|
| 7 |
Firmly attach the lifting platform safety devices (01) to the lifting platform support arms using the tensioning straps |
|
|
| 8 |
Remove in the reverse order. |
|
|