Gaps on hoods, doors and lids - AR60.00-P-0700-01T
TEST VALUES FOR GAPS ON HOODS, DOORS AND LIDS
| Number | Designation | Model 211.0 | |||
|---|---|---|---|---|---|
| BE60.00-P-1001-01F | Gap | Engine hood to fender | Dimension "A" | mm | 4.5 (±0.5) |
| Engine hood to headlamp | Dimension "B" | mm | 3.5 (+1) | ||
| Radiator grille to bumper | Dimension "C" | mm | 5 (+1) | ||
| Fig. see | AR60.00-P-0700-01T | ||||
| BE60.00-P-1002-01F | Gap | Front door to A-pillar | Dimension "D" | mm | 4.5 (± 0.5) |
| Front door to front fender | Dimension "E" | mm | 4 (± 0.5) | ||
| Front door to rear door | Dimension "F" | mm | 4 (+1) | ||
| front door and roof | Dimension "G" | mm | 4.5 (± 0.5) | ||
| Rear door to upper side section | Dimension "H" | mm | 4.5 (± 0.5) | ||
| Rear door to bottom side section | Dimension "I" | mm | 3.5 (± 0.5) | ||
| Fig. see | AR60.00-P-0700-01T | ||||
| BE60.00-P-1003-01F | Gap | Trunk lid to top of rear fender | Dimension "J" | mm | 3.5 (+1) |
| Trunk lid to taillamp | Dimension "K" | mm | 3.9 (+1) | ||
| Trunk lid to bumper | Dimension "L" | mm | 6.5 (-0,5/+1) | ||
| Rear fender to taillamp | Dimension "M" | mm | 2.5 (± 0.5) | ||
| Trunk lid cover to taillamp | Dimension "N" | mm | 4.3 (+1) | ||
| Fig. see | AR60.00-P-0700-01T | ||||
| BE60.00-P-1004-01F | Gap | Tank flap | Dimension "O" | mm | 3.5 (± 0.5) |
| Fig. see | AR60.00-P-0700-01T | ||||
Adjust hoods, doors and lids as shown in drawing. The gap should not run wedge-shaped or be too narrow at points.
Deviations from parallel gap should be max.
0.5 mm over the entire length. If the inside clearance is too large or too small, the movable body parts must be centered accordingly. The flat rates apply only for repair work on body damaged in an accident.