Arrangement and assignment of Z connector sleeves (solder splices in wiring harness) - engine compartment (right) - GF00.19-U-3000-02DA
MODEL 211
| Z conn. sleeve | Designation | Comp. | Designation | Conn. pin |
|---|---|---|---|---|
| Z5/1z1 | Blower connector sleeve | |||
| M156 | ← N3/10 | ME-SFI [ME] control module | 2.43 | |
| M156 | → R15 | Electric suction fan series resistor | ||
| Z5/1z2 | Blower connector sleeve | |||
| M156 | ← R15 | Electric suction fan series resistor | ||
| M156 | → M4/7 | Electric suction fan engine and AC with integrated control | 4 | |
| Z6/49 | Ground (W2) connector sleeve | ← W2 | Ground (at right headlamp unit) | |
| → B32/2 | C-AAC sun sensor (4 in total) | 1 | ||
| → H2 | Fanfare horns | 1 | ||
| → S10/2 | Right front brake pad contact sensor | |||
| → X62/6 | Right front axle multiple circuit junction connector, in component compartment | 2.2 | ||
| Z6/49z1 | Ground (W2) connector sleeve | |||
| ← W2 | Ground (at right headlamp unit) | |||
| M272 | → B11/15 | PremAir sensor | x1.1 | |
| UP TO 05/06 | → E2 | Right front headlamp unit | S2.1 S3.1 |
|
| Valid for xenon headlamps, UP TO 05/06 | → E2 | Right front headlamp unit | S4.1 | |
| → E5/2 | Right fog lamp | 1 | ||
| AS OF 06/06 | → E6/2 | Right front side marker lamp {{USA}} | 1 | |
| → M13 | Coolant circulation pump | 2 | ||
| M156 AS OF 06/06 | → X99/1 | Separation point 1 | 1.1 | |
| Z6/49z8 | EDW [ATA] ground connector sleeve | ← N10/2 | Rear SAM control module with fuse and relay module | 4.6 |
| UP TO 05/06 | → B33 | ATA [EDW] inclination sensor | 5 | |
| → H3/1 | Alarm signal siren | 2 | ||
| → S62 | ATA [EDW] hood switch | 1.1 | ||
| Z7/24 | Circuit 87 connector sleeve | |||
| UP TO 05/06 | ← F30 | Second battery additional fuse | E | |
| UP TO 05/06 | → G1/7 | Auxiliary battery | 3 | |
| M113 AMG, UP TO 05/05 | → K27/1 | Fuel pump relay module | 2 | |
| UP TO 05/06 | → K57/2 | Auxiliary battery relay | 1.1 2 |
|
| M113 AMG, UP TO 05/05 | → M3 | Fuel pump (FP) | ||
| M113 AMG, UP TO 05/05 | → X36/3 | Fuel pump wiring harness connector | 1.1 1.4 |
|
| Z36/4 | Front PTS sensor voltage supply connector sleeve | → N62 | PTS control module | B.34 |
| UP TO 05/06 | ← A42 | PTS sensor unit, front bumper | 1.4 2.4 3.4 4.4 5.4 6.4 |
|
| AS OF 06/06 | → B8/1 | Outer left front PTS ultrasonic sensor | 3 | |
| AS OF 06/06 | → B8/2 | Center left front PTS ultrasonic sensor | 3 | |
| AS OF 06/06 | → B8/3 | Inner left front PTS ultrasonic sensor | 3 | |
| AS OF 06/06 | → B8/4 | Inner right front PTS ultrasonic sensor | 3 | |
| AS OF 06/06 | → B8/5 | Center right front PTS ultrasonic sensor | 3 | |
| AS OF 06/06 | → B8/6 | Outer right front PTS ultrasonic sensor | 3 | |
| → X26/27 | Front PTS separation point | 1 |