Connect wiring harness - AZ82.20-P-0001-02T
Connection diagram for wiring harness, illuminated door sill molding (4x) as shown on model 211.0
Fig 1: Connection Diagram For Wiring Harness, Illuminated Door Sill Molding (4x) - Shown On Model 211.0
- Connect wiring harness (6) with connection coupling to plug position 27 at rear SAM control unit with fuse and relay module (N10/2).
- Put relay (7) onto plug position C and assign fuse (8) on fuse location 5 with a 7.5 A fuse.
- Route wiring harness (6) in trunk along existing leads as shown in figure.
- Connect brown ground lead to ground connection (arrow).
- Route branch-off line from wiring harness (6) for the illuminated door sill moldings in the cable duct under the left and right rear door (only with 4 door sill moldings).
- Attach inverter (3) and route in cable duct.
- Route branch-off line for illuminated door sill molding in cable duct at driver's door, right and left.
- Attach inverter (3) and route in cable duct.
- Put on relevant door sill at every affected door and drill and varnish 6 mm diam. hole (arrow) in weatherstrip fold of sill, level with relevant line terminator.
Make hole as far onto lower weatherstrip fold as possible.
- Clip illuminate door sill molding on and route connecting wire (11) through drilled hole.
- Insert 2 pins of connecting wire (11) into a connector housing (4) and attach to wiring harness (6).
- Connect the two-color door contact wire to branch-off line of same color in wiring harness (6) using provided clamping connector at each of the doors concerned.