Cavity preservation following repair work - AR97.20-P-1500Q

MODEL 209.3 

Engine hood 

Fig 1: Identifying Cavity Preservation Repair Area - Engine Hood

Courtesy of MERCEDES-BENZ USA

Front wheelhouse 

Fig 2: Identifying Cavity Preservation Repair Area - Front Wheelhouse

Courtesy of MERCEDES-BENZ USA

Shown on model 203.0 

Fig 3: Identifying Cavity Preservation Repair Area - Wheelhouse Longitudinal Member

Courtesy of MERCEDES-BENZ USA

Right and left rear wheelhouse longitudinal member 

Driver's door 

Fig 4: Identifying Cavity Preservation Repair Area - Driver's Door

Courtesy of MERCEDES-BENZ USA

Rear window shaft, rear fender and side longitudinal member (inner front) 

Fig 5: Identifying Cavity Preservation Repair Area - Rear Window Shaft, Rear Fender And Side Longitudinal Member (Inner Front)

Courtesy of MERCEDES-BENZ USA

Overall front, rear longitudinal member and underbody 

Fig 6: Identifying Cavity Preservation Repair Area - Overall Front, Rear Longitudinal Member And Underbody

Courtesy of MERCEDES-BENZ USA

	Risk of explosion  and poisoning  caused by solvent vapors and gasses. Risk of injury  to skin and eyes when handling anticorrosion agents.	Never spray anticorrosion agents on flames or glowing hot objects and keep them well away from all potential sources of ignition. Use them only in well-ventilated rooms; wear respiratory protection.	AS97.00-Z-0001-01A
	Notes on cavity preservation	Model 124, 126, 129, 140, 168, 169, 170, 171, 201, 202, 203, 208, 209, 210, 211, 215, 220, 230, 240, 463, 639, 671, 690.6, 901, 902, 903, 904, 905 Model WD1, WD2, WD3, WD6, WD7, XD1, XD2, XD3, XD4, XD5, XD6, XD7, YD1, YD2, YD3, YD4, YD5, YD6, YD7	AH97.20-P-0001-01B
1	Perform repair preservation	Apply cavity preservation agent from inside in shaded areas following sealing and paintwork, however, before performing assembly work. Apply repair preservation agent twice with a drying time of 5 minutes in between The spraying hose should be stiff and the nozzles should spray at angle to the front and rear. The cavities should be dry. Insert spray hoses as far as possible into cavities. Spray while inserting and pulling out slowly.
	Processing instructions for cavity preservation agent		AP97.20-P-0640-01A
	Cavity protection, general		GF98.00-P-2045A
		Cavity preservation gun Sata HRS no. 11072 http://gotis.aftersales.mercedes-benz.com
		MB cavity wax preservation, 1 l	*BR00.45-Z-1003-05A
2	Remove cavity preservation agent from drain holes	The processing temperature should not be less than 15°C. Additional preservation measures may be required depending on the repair area deviating from the standard cavity preservation illustrated.