Remove/install xenon bulb ignition module - AR82.10-P-4633QA
MODEL 209 as of 17.5.05 with CODE (614) Bi-xenon headlamp unit
MODEL 209 as of 17.5.05 except CODE (615) Bi-xenon headlamp unit with integrated curve illumination
Shown with code 615 Bi-xenon headlamp unit with integrated curve illumination
| Remove/install | |||
|---|---|---|---|
| Risk of death
caused by high voltage levels present at xenon headlamps. Risk of explosion/fire hazard due to highly flammable substances in the area of damaged xenon bulbs Risk of injury due to UV light, hot components on xenon headlamps and glass splinters when xenon bulbs burst Risk of poisoning caused by inhalation of mercury vapors and by toxic salts and mercury compounds being ingested or coming into contact with skin |
Do not come into contact with parts that are under high voltage. Persons with active electronic implants (e.g. heart pacemakers) must never work on xenon headlamps. Switch off entire lighting system. Wear insulated safety shoes, safety glasses and protective gloves. Remove highly inflammable materials from the hazard area. Ensure sufficient ventilation in the working area. | AS82.10-Z-0001-01A | |
| 1 | Switch off the ignition and remove the transmitter key from the EIS control unit | ||
| 2 | Open engine hood and secure against falling down | AR88.40-P-1000Q | |
| 3 | Remove air pump | Vehicles with code P98 Black Series for removal of left xenon headlamp ignition module (E1n2) | |
| 4 | Turn housing cover (low beam) (1) from left/ right front lamp unit (E1/E2) to left and remove | ||
| 5 | Disconnect electrical connector (3) from xenon headlamp ignition module (E1n2/E2n2) | ||
| 6 | Turn xenon headlamp ignition module (E1n2/ E2n2) to the left and carefully pull out with left/right low beam (E1e2/E2e2) | ||
| 7 | Install in the reverse order | ||
| 8 | Perform a function test |