Remove/install antenna amplifier module - AR82.62-P-8300P: Notes

MODEL 203.0 /7, 209.3 

Illustrated on model 203.0 

Fig 1: Identifying Antenna Amplifier Module Components - Illustrated On Model 203.0

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

MODIFICATION NOTES

16.8.06

Attachment of protective foil added

AR82.62-P-8300-05P

	Remove/install
	Notes on avoiding damage to electronic components due to electrostatic discharge		AH54.00-P-0001-01A
1.1	Detach headliner and place down to front	Model 203.0	AR68.30-P-4300P
		Model 209.3	AR68.30-P-4300Q
1.2	Remove rear window	Model 203.7	AR67.20-P-2000PB
2	Detach AM/FM antenna module connector (X1/19)	Remove from bracket (3) at left C-pillar.
3	Detach intermediate frequency antenna module connector (X1/20)	Remove from bracket (3) at left C-pillar.
4	Separate antenna module supply connector (X1/22)	Remove from bracket (3) at left C-pillar.
5	Unclip center wirings (1)
6	Remove line
7	Unclip left wirings (2)
8	Remove line
9	Remove antenna amplifier module sealing rail	Model 203.7 Installation:  If no sealing rails have been attached to the vehicle, they must be retrofitted.	AR82.62-P-8300-05P
10	Detach amplifier module 1, window antenna (A2/71) from rear window	Carefully heat repair area using hot air gun.
		Mounting wedge	Fig 2
		Hot air gun - 3000 W
		Installation:  When gluing on the amplifier module 1, window antenna (A2/71), please ensure that it is attached to the rear window immediately after removing the protective foil on the adhesive pad. Once positioned, pressure must be applied to the amplifier module 1, window antenna (A2/71) for approx. 5 seconds.
		If no sealing rails are installed in model 203.7, a protective foil must be attached in the area of the heat conductor before installing the amplifier module 1, window antenna (A2/71). See: ↓
		Remove/install antenna amplifier module sealing rail	AR82.62-P-8300-05P
11	Remove adhesive residues from rear window	Installation:  Use Sika activator and treat bonding surface on rear window with Sika primer 206 G+P bonding agent.
		Activator	*BR00.45-Z-1023-04A
		Bonding agent Sika primer 206 G+P	*BR00.45-Z-1019-02A
12	Install in the reverse order

Special tools 

Fig 2: Identifying Wedge Tool (110 589 03 59 00)

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

REPAIR MATERIALS

Number	Designation	Order number
BR00.45-Z-1019-02A	Bonding agent Sika primer 206 G+P	Sika Deutschland GmbH Stuttgarter Strasse 139 72574 Bad Urach Germany Tel. +49 7125 940-761 Fax +49 7125 940-763 www.sika-industry.de
BR00.45-Z-1023-04A	Activator	A 005 989 58 71