Remove/install xenon headlamp control unit - AR82.10-P-4632Q
MODEL 209 with CODE (614) Bi-xenon headlamp unit
MODEL 209 with CODE (615) Bi-xenon headlamp unit with integrated curve illumination
Shown with code 615 Bi-xenon headlamp lamp unit with integrated curve illumination removed from lamp unit on left-hand side
Fig 1: Identifying Xenon Headlamp Control Unit Components - Shown With Code 615 BI-Xenon Headlamp Lamp Unit With Integrated Curve Illumination Removed From Lamp Unit On Left-Hand Side
Shown with code 615 Bi-xenon headlamp lamp unit with integrated curve illumination installed on lamp unit on right hand side
Fig 2: Identifying Xenon Headlamp Control Unit Components - Shown With Code 615 BI-Xenon Headlamp Lamp Unit With Integrated Curve Illumination Installed On Lamp Unit On Right Hand Side
| Remove/install | |||
|---|---|---|---|
| Risk of death
caused by high voltage levels present at xenon headlamps. Risk of explosion/fire hazard due to highly flammable substances in the area of damaged xenon bulbs Risk of injury due to UV light, hot components on xenon headlamps and glass splinters when xenon bulbs burst Risk of poisoning caused by inhalation of mercury vapors and by toxic salts and mercury compounds being ingested or coming into contact with skin |
Do not come into contact with parts that are under high voltage. Persons with active electronic implants (e.g. heart pacemakers) must never work on xenon headlamps. Switch off entire lighting system. Wear insulated safety shoes, safety glasses and protective gloves. Remove highly inflammable materials from the hazard area. Ensure sufficient ventilation in the working area. | AS82.10-Z-0001-01A | |
| 1.1 | Remove left front lamp unit (E1) | Vehicles without code P98 Black Series |
AR82.10-P-4730QA |
| 1.2 | Remove front section of fender liner in left front fender | Vehicles with code P98 Black Series |
AR88.10-P-1300P |
| 2.1 | Remove front section of right fender liner in the front fender | Vehicles without code P98 Black Series |
AR88.10-P-1300P |
| 2.2 | Remove right front lamp unit (E2) | Vehicles with code P98 Black Series |
AR82.10-P-4730QA |
| 3 | Remove bolts (1) | ||
| 4 | Carefully pry off xenon headlamp control unit (E1n1) from left front lamp unit (E1) or xenon headlamp control unit (E2n1) from right front lamp unit (E2) | ||
| Figure | |||
| 5 | Install in the reverse order | ||
| 6 | Conduct adaptation of xenon headlamp control unit | Only when replacing xenon headlamp control unit (E1n1 or E2n1). | |
| Connect STAR DIAGNOSIS and read out fault memory | AD00.00-P-2000-04A | ||
| 7 | Check headlamp setting and correct if necessary | ||
| Check and correct headlamp adjustment | AP82.10-P-8260P |