Remove/install rear axle headlamp range adjustment sensor - AR82.10-P-4084P

MODELS 203 with CODE (612) Xenon headlamp unit 

MODELS 209 with CODE (614) Bi-xenon headlamp unit 

except CODE (P98) Black Series 

MODELS 209 with CODE (615) Bi-xenon headlamp unit with integrated curve illumination 

except CODE (P98) Black Series 

Shown on model 203 

Fig 1: Identifying Rear Axle Headlamp Range Adjustment Sensor Components - Shown On Model 203

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

Fig 2: Identifying Headlamp Range Adjustment Rear Axle Sensor And Bracket

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

	Remove/Install
	Risk of death  caused by vehicle slipping or toppling off of the lifting platform.	Align vehicle between the columns of the lifting platform and position the four support plates at the lifting platform support points specified by the vehicle manufacturer.	AS00.00-Z-0010-01A
1	Raise vehicle.		AR00.60-P-1000P
2	Press out clip (2)	Unclip clip (2) from headlamp range adjustment rear axle sensor (A51).
3	Disconnect connector (3)
4	Press rod (4) off of ball pivot (5).
5	Screw off nuts (6)	Nuts (6) of bracket (9) to rear axle carrier.
6	Remove rear axle sensor (headlamp range adjustment) (A51)
7	Unscrew ball pivot (5)
8	Remove bolts (8)
9	Remove bracket (9)	Remove mount (9) from rear axle sensor (headlamp range adjustment) (A51)
10	Install in the reverse order
11	Check headlamp setting, correct if necessary
	Check and correct headlamp setting		AP82.10-P-8260P