Remove/install lamp unit holder - AR82.10-P-4740P

MODEL 203, 209 

Shown on model 203.0 

Fig 1: Identifying Lamp Unit Holder Components - Shown On Model 203.0

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

MODIFICATION NOTES

24.5.06

"Disconnect/connect ground line on battery" removed

	Removing
	Risk of injury  caused by scraping or cutting body parts on sharp vehicle parts	Always wear protective gloves when working on or near sharp and non-deburred vehicle parts. Deburr repair panels.	AS00.00-Z-0017-01A
1	Remove lamp unit	Model 203	AR82.10-P-4730PA
		Model 209	AR82.10-P-4730QA
2	Cut off outer bracket (1), middle bracket (2) and inner bracket (3)	Saw off at separation points provided (arrow).
		Body saw (electric/pneumatic)	*WE58.40-Z-1004-03A
3	Clean and deburr separation points on lamp unit
	Install
4	Remove adjusting bushes (4)	Transfer height of adjusting bushes (4) from respective holder to new parts.
5	Screw new holders to lamp unit
6	Install lamp unit	Adjust lamp unit evenly to body at adjusting bushes (4)
		Model 203	AR82.10-P-4730PA
		Model 209	AR82.10-P-4730QA

WORKSHOP EQUIPMENT

WE58.40-Z-1004-03A

Body saw (electric/pneumatic)