Remove/install paneling on C-pillar - AR68.30-P-4490MC

MODEL 220.175 /178 with CODE (Z04) Light armoring with CODE (Z07) Top protection 

Fig 1: Identifying Removal/Installation Paneling On C-Pillar - Model 220.175/178

	Remove/install
1	Detach edge guard in area of paneling parts (1 and 6)
2	Remove lordotic support control valve		AR91.12-P-1670M
3	Remove inner door sill molding	Door sill molding is bolted on in area of lordotic support control valve (arrow).
4	Remove wheel well paneling (6)	Secured using 3 bolts.
5	Unclip SRS cover (9) and unscrew bolt underneath
6	Unclip paneling (1) from C-pillar	Position longitudinal wedge directly on clip (2).
			Figure
7	Guide out hook (3) at headliner
8	Pull C-pillar paneling (1) with tabs (4) out of parcel shelf and to the front
9	Unscrew bolt (7) at belt end fitting (8) of rear seat belt and pull out belt at paneling (1)		*BA91.40-P-1001-01A
10	Install in the reverse order

SEAT BELTS/EMERGENCY TENSIONING RETRACTORS

Special tools 

Fig 2: Identifying Longitudinal Wedge (115 589 03 59 00)