Replace rubber mounts of rear shock absorbers - AR32.25-P-1871M

MODEL 215 

MODEL 220 except CODE (Z07) Top protection except CODE (Z04) Light armoring 

Fig 1: Identifying Spring Control Arm, Rubber Bushing And Bearing Shell Collar

Fig 2: Identifying Bearing Seat And Suspension Strut

	Removing
	Risk of death  caused by vehicle slipping or toppling off of the lifting platform.	Align vehicle between the columns of the lifting platform and position the four support plates at the lifting platform support points specified by the vehicle manufacturer.	AS00.00-Z-0010-01A
	Replace self-locking nuts and bolts		AH00.00-N-0001-01A
	Special information on AIRmatic		AH32.22-P-1000-02I
	General information	Replacement of the rubber mounts (2) on the rear shock absorbers in pairs is not inevitable.
1.1	Empty suspension strut (4) of rear axle using STAR DIAGNOSIS	Model 220 except CODE (487) Active Body Control (ABC)
	Connect STAR DIAGNOSIS		AD00.00-P-2000-04A
2	Remove rear wheel
	Remove/install wheels, rotate if necessary		AP40.10-P-4050Z
3	Remove spring control arm (1)	Unhook exhaust system on both rear exhaust-rubber mounts.
		Model 215, 220 with CODE (487) Active Body Control (ABC)	AR35.20-P-0114N
		Model 220 except model 220.875/878, except CODE (487) Active Body Control (ABC)	AR35.20-P-0114I
		Model 220.875/878	AR35.20-P-0114MP
4	Remove rubber mounts (2) using extraction and insertion tool (01)		Fig 3
5	Clean and check bearing seat (3)
	Install
6	Install rubber mounts (2) using extraction and insertion tool (01)	Do not squeeze plastic parts (large arrow) of the rubber mount (2). Cracked plastic parts result in corrosion and thus to damage to the rubber mount(2).
			Fig 3
7	Check installation position of the rubber mount (2)	Carry out visual inspection of distances (small arrows) from outer bearing shell collar (2b) to the bearing seat edge (3k). In the event of unequal distances (small arrows) correct the installation position using the extraction and insertion tool (01).
			Fig 3
8	Install spring link (1)	Unhook exhaust system on both rear exhaust-rubber mounts.
		Model 215, 220 with CODE (487) Active Body Control (ABC)	AR35.20-P-0114N
		Model 220 except model 220.875/878, except CODE (487) Active Body Control (ABC)	AR35.20-P-0114I
		Model 220.875/878	AR35.20-P-0114MP
9	Remount the rear wheel
	Remove/install wheels, rotate if necessary		AP40.10-P-4050Z
10.1	Fill the suspension strut (4) using STAR DIAGNOSIS	Model 220 except CODE (487) Active Body Control (ABC) The wheels must not touch the ground while pressurizing because the air bellows in the suspension strut (4) will be destroyed if pressurized with the suspension compressed.
	Connect STAR DIAGNOSIS		AD00.00-P-2000-04A
11.1	Check AIRmatic for leaks.	Model 220 except CODE (487) Active Body Control (ABC)	AR32.22-P-8100I

Fig 3: Identifying Extraction And Insertion Tool (202 589 00 43 00)