Removing and installing seal for sliding/pop-up roof panel - AR77.20-P-1300M

MODEL 202 with CODE (412b) Electric sliding/pop-up roof with CODE (414a) Electric glass sliding/pop-up roof 

MODEL 210 with CODE (414a) Electric glass sliding/pop-up roof 

MODEL 215 with CODE (414a) Electric glass sliding/pop-up roof 

MODEL 220 with CODE (414a) Electric glass sliding/pop-up roof 

Fig 1: Identifying Seal For Sliding/Pop-Up Roof Panel Components

	Removal
1	Remove wind deflector		AR77.20-P-2500E
2	Loosen screws (6)
3	Unscrew seal (1) from rails (2, 3, 4, 5)	Carefully pull seal (1) out of rail (2) because barbs are present on the rail
	Installation
4	Push rail (2) up until the spacers (7) are against the roof and tighten screws (6)
5	Press seal (1) into rails (3, 4, 5) at the points marked with arrows with the grooves pointing up.	Use lubricant	*BR00.45-Z-1010-06A
6	Install wind deflector		AR77.20-P-2500E