Check and correct headlamp adjustment - AP82.10-P-8260M: Notes
MODEL 215, 220
MODIFICATION NOTES
| 25.6.03 | Risk of death due to high voltage at Xenon headlamps, safety instructions newly included |
| Check | |||
| Risk of death
caused by high voltage levels present at xenon headlamps. Risk of explosion/fire hazard through highly flammable material in the area of damaged xenon lamps Risk of injury through UV light, hot components on xenon headlamps and glass splinters when xenon bulbs burst Risk of poisoning through inhalation of mercury vapor and swallowing of or skin contact with toxic salts and mercury compounds |
Do not come into contact with parts that are under high voltage. Persons with active electronic implants (e.g. heart pacemakers) must never work on xenon headlamps. Switch off complete lighting system. Wear insulating safety shoes, safety glasses and protective gloves. Remove highly inflammable materials from the hazard area. Ensure that the workplace is sufficiently ventilated. | AS82.10-Z-0001-01A | |
| Risk of accident caused by vehicle starting off by itself when engine is running. Risk of injury caused by contusions and burns during starting procedure or when working near the engine as it is running | Secure vehicle to prevent it from moving by itself. Wear closed and snug-fitting work clothes. Do not touch hot or rotating parts. |
AS00.00-Z-0005-01A | |
| 1 | Park vehicle on a level surface. | ||
| 2 | Correct tire inflation pressure | ||
| 3.1 | Have person sit on driver seat or place load of 75 kg on seat. | Except |
|
| 4 | Allow engine to run for approx. 30 seconds at a moderate rpm and press switch for level control | ||
| 5 | Align headlamp adjustment testing unit to the vehicle and carry out height setting according to middle of the lens. | ||
| *WE58.40-Z-1006-19A | |||
| 6 | Start the engine and switch on low beam | ||
| 7.1 | Check function of headlamp range adjustment by adjusting headlamp range adjustment switch | Except bi-xenon headlamp unit CODE (614) or |
|
| 7.2 | Check function of headlamp range adjustment through placement of additional weights in the luggage compartment | With bi-xenon headlamp unit CODE (614) or |
|
| 8.1 | Remove additional weights from the luggage compartment | With bi-xenon headlamp unit CODE (614) or |
|
| 9 | Check low beam, if required correct setting | AP82.10-P-8260-01A | |
| 10 | Check setting of high beam | AP82.10-P-8260-02A | |
| 11 | Check fog lamp, if required correct setting | AP82.10-P-8260-04A | |
| 12 | Turn off engine |
WORKSHOP EQUIPMENT
| WE58.40-Z-1006-19A | Headlamp adjustment testing unit |