Remove/install hydraulic line of power steering - AR46.25-P-3015M

MODELS 220.176 

Hydraulic line (supply line) from expansion reservoir to power steering pump 

Fig 1: Identifying Left Engine Air Intake Duct, Supply Line And Power Steering Pump

	Remove/Install
	Before opening the hydraulic system the area surrounding the separation point should be cleaned thoroughly. Even the smallest dirt particles, introduced into the hydraulic components, can lead to malfunctions and a total failure of the hydraulic system
1	Open engine hood		AR88.40-P-1000M
2	1 Remove left engine intake air duct (1) upstream of the air cleaner housing
3	Suction off oil out of expansion reservoir (2) of power steering pump (4)	Hand pump	Figure
4	Detach supply line (3) from expansion reservoir (2) and from power steering pump (4)	Seal connections immediately with plugs.
		Set of plugs	Figure
		Hose clamp pliers with Bowden cable	*WH58.30-Z-1017-02A
5	Install in the reverse order
6	Fill and bleed power steering pump (4)		AR46.30-P-0010N
7	Check power steering for proper operation and hydraulic line connections for leaks

Fig 2: Set Of Plugs (129 589 00 91 00)

Fig 3: Hand Pump (210 589 00 71 00)