Cranking the engine - AR01.00-P-0100M

ENGINE 628.960 in MODELS 220.028 /128 Crank engine at the torque converter 

ENGINE 628.961 in MODEL 211.028 Crank engine at the torque converter 

ENGINE 275.950 in MODEL 220.176 Crank engine at the torque converter 

Fig 1: Identifying Cover, Torque Converter And Converter Housing

	Removing/installing
	Risk of death caused by vehicle slipping or toppling off the lifting platform.	Align vehicle between the columns of the hydraulic hoist and position the four support plates below the hoist support points specified by the vehicle manufacturer.	AS00.00-Z-0010-01A
1.1	Remove rear part of sound installation bottom section	Model 211	AR94.30-P-5300T
		Model 220	AR94.30-P-5300M
1.2	Detach rear part of lower engine compartment paneling	Model 220	AR61.20-P-1105M
2	Remove cover (1)
3	Crank engine using a wide screwdriver (2) stepwise in the direction of rotation of the engine (arrow)	Place the screwdriver blade on the torque converter (3) and support the screwdriver shaft on the converter housing (4).
4	Install in reverse order