Pressure gauge connection caused by swallowing brake fluid. caused by brake fluid coming into contact with skin and eyes. - AR42.50-P-0001-01MB
 |
Risk of poisoning
caused by swallowing brake fluid. Risk of injury
caused by brake fluid coming into contact with skin and eyes. |
Pour brake fluid only into suitable and appropriately marked containers. Wear protective clothing and eye protection when handling brake fluid. |
AS42.50-Z-0001-01A |
COMMERCIALLY AVAILABLE TOOLS
| Number |
Designation |
| WH58.30-Z-1012-15A |
Pressure tester (hydraulic single / dual circuit brake systems) |
| WH58.30-Z-1003-23A |
Distributor |
A 116 990 02 72 |
- Switch off ignition.
- Release pressure from booster circuit (by depressing brake pedal approximately 30 times).
- Screw out the nuts (1) on the hydraulic line (2).
- Remove angled fitting (3) from hydraulic line.
- Install adapter (4) and distribution module (5) between angled fitting (3) and hydraulic line.
Instead of the adapter (2 M10x1 outside threaded fittings) a short length of brake line bent to the desired configuration can also be installed.
- Connect test line (6) from pressure gauge to adapter (5).