Remove/install control cable for engine hood - AR88.40-P-3100MA

MODEL 215, 220 Front engine hood control cable 

Shown on model 220 

Fig 1: Identifying Engine Hood Control Cable Remove/Install Components - Shown On Model 220

	Remove/Install
1	Open engine hood and raise to vertical position		AR88.40-P-1000M
2	Remove engine hood lock	Model 215. Left engine hood lock (2) and right engine hood lock (3)	AR88.40-P-3200N
		Model 220. Left engine hood lock (2) and right engine hood lock (3)	AR88.40-P-3200M
3	Unhook coupling (6) from front end, fold open and unhook rear engine hood control cable (1) from coupling (6).	Do not twist coupling (6)
4	Unhook front engine hood control cable (5) from upper frame cross member (4)	Installation:  First route engine hood control cable to right engine hood lock (3) and tightly below upper frame cross member (4)
5	Unhook front engine hood control cable (5) from front end and remove with coupling (6)	Installation:  The individual engine hood control cables of the front engine hood control cable (5) should run parallel
6	Install in the reverse order
7	After installing, check left (2) and right (3) engine hood lock and safety hook for proper function