Pressing out and pressing in radial seal ring on side of rear axle housing - AR35.31-P-0540-05H

Replace radial seal ring and smear sealing lip with Universal hypoid transmission fluid: ↓ 

Universal hypoid transmission fluids (SAE 85 W-90) 

Fig 1: Identifying Alignment Tool (126 589 04 15 00)

Pressing out 

1. Press radial seal ring (32a) out of the housing using a suitable screwdriver.

   Shown on 185 mm dia. rear axle center assembly without side bearing cover 

   Fig 2: Pressing Radial Seal Ring Out Of The Housing Using A Suitable Screwdriver - Shown On 185 Mm Dia.

   

   Shown on 210 mm dia. rear axle center assembly with side bearing cover 

   Fig 3: Pressing Radial Seal Ring Out Of The Housing Using A Suitable Screwdriver - Shown On 210 Mm Dia.

   

Pressing in 

2. Smear sealing lip of new radial seal ring (32a) with Universal hypoid transmission fluid.
3. Press in radial seal ring (32a) with alignment tool (032c).

Shown on 185 mm dia. rear axle center assembly 

Fig 4: Press In Radial Seal Ring With Alignment Tool - Shown On 185 Mm Dia.

Shown on 210 mm dia. rear axle center assembly 

Fig 5: Press In Radial Seal Ring With Alignment Tool - Shown On 210 Mm Dia.