Retrofitting cargo retainers - AN68.50-P-0003P

MODEL 203.0 except CODE (287a) Through-loading feature

Fig 1: Identifying Trunk Floor Paneling, Cuts And Front Anchoring Lug

G04737397

Fig 2: Identifying Cargo Screw, Nut And Cap

G04737398

	Removing
1	Remove trunk floor paneling (3)
2.1	Unscrew screws (1)	With code (550) trailer hitch.
2.2	Unscrew nuts (1)	Except code (550) trailer hitch
3	Remove caps (2)
	Installation
4	Install front anchoring lugs (4)	Screw for anchoring lug in trunk at front	*BA68.50-P-1002-03A
5	Install rear anchoring lugs (5)	With code (550) trailer hitch.
		Bolt with anchoring lug, trailer hitch to rear end center assembly Except code (550) trailer hitch	*BA31.11-P-1004-01C
		Nut with anchoring lug on rear bumper on longitudinal member	*BA68.50-P-1001-03A
6	Cut trunk floor paneling (3)	Make 50 mm lateral cut in trunk floor paneling (3) in area of anchoring lugs.
7	Insert trunk floor paneling (3)	Pull anchoring lugs through cuts (3a) in trunk floor paneling (3).

TORQUE SPECIFICATION

TRAILER HITCH MECHANICS

Number	Designation		Model 203
BA31.11-P-1004-01C	Bolt with lashing point, trailer hitch at rear center panel	Nm	55

TORQUE SPECIFICATION

CARGO RETAINER

Number	Designation		Model 203
BA68.50-P-1001-03A	Nut with anchoring lug on rear bumper on longitudinal member	Nm	55
BA68.50-P-1002-03A	Screw for anchoring lug in trunk at front	Nm	20

PARTS ORDERING NOTES

Part no.	Designation	Quantity
A203 860 00 14	Rear anchoring lug	2
A210 860 02 14	Front anchoring lug	2
A210 984 09 29	Screw	2