Destination guidance in non-digitalized map area, function - GF82.61-P-4001PM

MODEL 203.0 /2 /7 as of 24.4.04 with CODE (527) COMAND APS with single DVD drive (with navigation) 

During trips outside of the digitized map area (e.g. company grounds, multi-level car parks, dirt tracks etc.), but still within the Digital Versatile Disk (DVD) map boundary, the navigation processor of the COMAND operating, display and control unit (A40/3) switches over to "Navigation in non-digitized map area". The following message appears on the COMAND operating, display and control unit (A40/3) display:

• "OFFROAD"

The following is displayed if the vehicle is outside the DVD map border (outside the country):

• "OFFMAP"

When entering the OFF ROAD mode, the map is displayed and route information shown.

In both cases only basic position finding (dead reckoning) with correction is performed using the global positioning system (GPS) data.

Limited destination guidance takes place while only specifying:

• straight-line distance to the destination
• direction to destination (as arrow).

After reentering the digitized map area, the system automatically continues with "Destination guidance in digitized map area". The GPS position is used to help determine the roads on which the vehicle could be located. During this process a slight delay in the route guidance may result.

When the message "OFF MAP" appears, navigation can be continued by inserting a corresponding DVD for the foreign country in question.