Notes on operating drawer - AH68.30-P-0001-01A
Model 203
The drawer should not be subjected to a load of more than 2.5 kg.
Protect objects sensitive to impact against sliding in drawer.
The drawer must always be inserted up to the end stop to protect against unintentional movement while driving.
The drawer has stops at the front and rear. The front stop limits the insert depth, the rear stop the extension path of the drawer.
An attempt to overcome the end stops with excessive force leads to damage to the drawer.
Observe the following when removing drawer:
- Pull drawer out to rear end stop.
- To overcome the end stop press catch on left and right drawer locks (6) inward against the spring force and simultaneously continue to pull drawer out.
Observe the following when installing the drawer:
- Press catch on left and right drawer locks (6) inward against spring force, position drawer on guide rails (4) and slide in to front stop.
- After approx. 100 mm it is possible to feel the locks engage in the rear stops (7). Only a slight increase in the pushing force is required to overcome the stops.