Destination guidance in digitalized map area, function - GF82.61-P-4000R

MODELS 203.0 /2 /7 up to 23.4.04 with CODE (352a) COMAND operating and display system with CODE (491) U.S. version 

During trips within the digitized map area, the following information calculated by the navigation processor of the COMAND operating, display and control unit (A40/3) is available to the user:

• The current route and position of the vehicle on a digital map (graphically depicted)
• Route list
• Distance from the destination and estimated time of arrival
• Direction recommendation
• Arrow indicating the driving direction
• Name of the road currently being traveled along
• Name of the next road into which the vehicle should turn
• Distance from the next junction (specified in units of length or as a bar graph)

Extension as from 1.6.01, the compass direction is displayed by North, South, East and West (through graphical display and voice output). The compass direction is displayed only in the case of numbered roads. No data and display of the compass direction is given in the case of roads designated by name (e.g. within towns).

For destination guidance, 3 illustration modes are possible:

• Map
• Map and symbol presentation of the turnoff points
• Symbol presentation (system of navigation symbols)

The scale of the map can be changed in stages (100 m/cm to 500 km/cm). In addition to this, it is possible to select whether the map is to be displayed in the direction of travel or to the North.

Blue Point Travelpilot DX navigation CD 

Separate direction lanes (fine geometry) are automatically displayed with this CD.

Extension; as from 1.6.01 the COMAND operating, display and control unit (A40/3) functions have been extended. The CD type (with the most up-to-date fine geometry) is recognized automatically and the graphics displayed in an optimized 2nd line thickness.

Actual destination guidance is significantly supported via voice output.