Installing control module - AZ54.65-P-0001-04M

Model 203.0 

1. Use ultrasonic PTS control module (62) as template and transfer holes (see arrow in figure section) to left side wall of trunk (see arrows).
2. Drill holes with 6.5 mm dia. bit (see arrows).
   Fig 1: Identifying PTS Control Module

   
3. Insert connector for ultrasonic back-up assist wiring harness (1) into plug location for ultrasonic PTS control module (62).

   Plug locations are coded and cannot be mixed up.

   Fig 2: Identifying PTS Control Module And Wiring Harness

   
4. Fasten ultrasonic PTS control module (62) with plug locations downward between fender and sheet metal part with 2 screws, lock washer and nuts.

   The screw head is located in the trunk (see arrows).

   Fig 3: Identifying PTS Control Module And Screw