Remove/install cigarette lighter - AR54.10-P-0030TX

MODEL 168, 170, 171, 203, 208, 209, 210, 211, 219, 230 

Fig 1: Identifying Cigarette Lighter Remove/Install Components - Shown On Model 219

Shown on model 219 

	Remove/install
1	Switch off ignition
2	Open ashtray
3	Pull insert (1) out of the housing (3) of the illuminated cigar lighter (R3)
4	Insert pliers (2) into the housing (3) and pull the housing (3) out of the clamping sleeve (4)	The spigots of the pliers (2) must engage in the cutouts of the housing (3) (arrows A).
			Fig 2
5	Disconnect electrical connector (6)
6	Unclip clamping sleeve (4) by pressing back the catch hooks (arrows B) from the ashtray housing (5) and remove	Installation:  Pay attention to the correct installation position of the clamping sleeve (4).
7	Install in the reverse order

Fig 2: Identifying Pliers (169 589 00 37 00)