Removing and installing front floor covering (left) - AR68.20-P-2050G

MODEL 170 

Fig 1: Identifying Front Floor Covering (Left) Remove/Install Components (1 Of 3)

Fig 2: Identifying Front Floor Covering (Left) Remove/Install Components (2 Of 3)

Fig 3: Identifying Front Floor Covering (Left) Remove/Install Components (3 Of 3)

	Removal
1	Remove front seat		AR91.10-P-1000G
2	Remove rear center console		AR68.20-P-2020G
3	Remove cover on center console		AR68.20-P-2350G
4	Remove ashtray housing with stowage compartment in front of center console		AR68.20-P-2410G
5	Remove air outlet cover in footwell		AR68.10-P-1530G
6	Remove paneling in left footwell		AR68.30-P-4010G
7	Remove pedal cover
8	Remove accelerator pedal	For this purpose unscrew nuts (2 each, 10 mm) and remove accelerator pedal from welded pin
9	Unhook ruffled pocket (1) and remove
10	Disconnect connector from parking brake switch and expose lead
11	Unscrew plugs (2 and 3) and remove rear edge guard (4) in lower area
12	Cut through floor covering (5) along dotted line with a sharp knife	. Do not damage electrical and pneumatic lines! Cut single-piece floor covering (5) along dotted lines in order to avoid time-consuming removal of the heater or air conditioning.
13	Remove floor covering (5) below center console	Lift at rear and remove from vehicle Lay floor covering (5) down on clean surface
	Installation
14	Prepare floor covering (5) for installation	Before installing floor covering, clean vehicle passenger compartment in area of floor covering. When replacing the floor covering cut the new floor covering along the dotted line with a sharp knife and remove the section below the heater (shaded area)
15	Install floor covering (5)	Insert cut edge in front area below center console while simultaneously guiding the parking brake lever, kick-down switch, welded pin for the accelerator pedal and electrical leads for the driver's seat through (arrows).
16	Expose lines in area of center console and attach the two halves of the floor covering at the front and rear with clips (6, 2 each) along the cutting line	For this purpose cut slits in both floor covering halves with blade and insert clips (6).
17	Reinstall in opposite order	starting with step 11