Removing, installing supporting joint at wheel carrier (wheel carrier installed) - AR35.20-P-0116B: Notes

MODEL 129, 170, 202, 208, 210 

Fig 1: Identifying Supporting Joint At Wheel Carrier Remove/Install Components

	Removing, installing
Installation	Replace self-locking nuts
	Lethal injuries  are possible if vehicle slips off of lifting platform	Align vehicle between the four pillars of the hoist and position the four support plates at the hoist mounting points specified by the vehicle manufacturer.	AS00.00-Z-0010-01A
1	Unclip line of brake lining wear indicator at spring link	If present
2	Remove spring link (6) at wheel carrier (7)	Installation:  The rear axle shaft must be horizontal when tightening the nuts.
		Replace self-locking nut.	*BA35.20-P-1002-01A
3	Press wheel carrier (7) up out of spring link (6)	Installation:  Do not damage rubber boots at supporting joint when installing in spring link.
4	Remove supporting joint (7a) at wheel carrier		AR35.20-P-0116-01B
		Extraction and insertion tool	Figure
5	Install in the reverse order

Spring link

Number	Designation		Model 129	Model 170	Model 202
BA35.20-P-1002-01A	Self-locking nut, spring link to wheel carrier	NM	120	120	120

Spring link

Number	Designation		Model 208	Model Series 210 except 210.07 with Code 979 and Code Z06
BA35.20-P-1002-01A	Self-locking nut, spring link to wheel carrier	NM	120	120

Fig 2: Identifying Removal And Installation Tool (202 589 00 43 00)