Removing and installing radiator for low temperature water circuit - AR09.41-P-6935R (SL600, SL65 AMG)
ENGINE 275 in MODEL 230
| Remove/Install | |||
|---|---|---|---|
| Risk of death. Death may result if vehicle slips or topples from the lifting platform. | Align vehicle between columns of lifting platform and position the four support plates below support points specified by vehicle manufacturer. | AS00.00-Z-0010-01A | |
| Risk of injury
to skin and eyes suffering scalding from contact with hot coolant spray. Risk of poisoning from swallowing coolant. |
Do not open cooling system unless coolant temperature is below 90°C. Open cap slowly and release the pressure. Do not pour coolant into beverage bottles. Wear protective gloves, protective clothing and eye protection. |
AS20.00-Z-0001-01A | |
| Risk of injury to fingers being jammed or squeezed when removing and installing or aligning hoods, doors, trunk lid/tailgate or sliding roof. | When moving components, ensure that no body parts or limbs are within the operating range of moving parts. | AS00.00-Z-0011-01A | |
| 1 | Open engine hood | AR88.40-P-1000R | |
| 2 | Dismount front bumper | AR88.20-P-2000R | |
| 3 | Slacken engine oil cooler (10) and hang on together with connected lines | AR18.30-P-1000R | |
| 4 | Dismount bracket (1) | ||
| 5 | Slacken expansion rivet (2) and dismount air ductings (3) | ||
| 6 | Drain the coolant out of the low temperature water circuit | AR20.00-P-1142HM | |
| Notes on coolant | AH20.00-N-2080-01A | ||
| 7 | Dismount coolant hoses (4) | ||
| 8 | Unscrew bolts (6) | ||
| 9 | Extend radiator for low temperature circuit (5) from side brackets (7) toward top and take out toward bottom | ||
| 10 | Install in the reverse order | ||
| 11 | Venting air from the low temperature circuit | AR20.00-P-1145H | |
| 12 | Inspect cooling system for leaks | AR20.00-P-1010HN |