Retrofit illuminated door sill molding - AZ82.20-P-0001RR: Notes

MODEL 230.### 1# as of model year 08 

Fig 1: Retrofitting Illuminated Door Sill Molding - As Of Model Year 2008 (1 Of 2)

Courtesy of MERCEDES-BENZ USA

Fig 2: Retrofitting Illuminated Door Sill Molding - As Of Model Year 2008 (2 Of 2)

Courtesy of MERCEDES-BENZ USA

	Removal
	Risk of death  caused by contact with parts conducting high voltages.	Do not touch parts which conduct high voltages. Persons who wear electronic implants (e.g. heart pacemakers) must not  perform any work on such components.	AS00.00-Z-0020-01A
1	Remove inner door sills on right and left	The old inner door sills are obsolete parts and are disposed of.	Fig 3
2	Remove rear passenger compartment side trim panel	Move both seats completely to front. Left and right side paneling. Model 230.4	AR68.30-P-4780R
3	Remove left and right rear luggage box	Place luggage box with lines connected to one side. Model 230.467/474/475/476 up to 14.1.04.	AR68.30-P-7440R
		Model 230.4 as of 15.1.04.	AR68.30-P-7440RA
4	Connect quiescent current retention unit	CMP 12.2 quiescent current retention unit
	Risk of explosion  caused by oxyhydrogen gas. Risk of poisoning and caustic burns  caused by swallowing battery acid. Risk of injury  caused by burns to skin and eyes from battery acid or when handling damaged lead-acid batteries	No fire, sparks, open flames or smoking. Wear acid-resistant gloves, clothing and glasses. Only pour battery acid into suitable and appropriately marked containers.	AS54.10-Z-0001-01A
5	Disconnect battery ground line		AR54.10-P-0003R
	Notes on battery	All models	AH54.10-P-0001-01A
	Install
6	Route wiring harness for illuminated door sill molding		AZ82.20-P-0001-02RR
7	Carry out function check	When the door contact switch is actuated the door sill molding illuminates but switches off again automatically after 5 minutes.
8	Install remaining parts onto vehicle	Operation steps 5 up to 1.

Fig 3: Identifying Assembly Wedge (110 589 03 59 00)

Courtesy of MERCEDES-BENZ USA

PARTS ORDERING NOTES

Part no.	Designation	Quantity
B6 689 01 58	Illuminated door sill moldings, black/stainless steel color	as required
B6 689 01 59	Illuminated door sill moldings, alpaca gray/stainless steel color	as required
B6 689 01 60	Illuminated door sill moldings, pebble beige/stainless steel color	as required
B6 603 10 64	Illuminated door sills black/stainless steel with "AMG" writing	as required
B6 603 10 65	Illuminated door sills alpaca gray/stainless steel with "AMG" writing	as required
B6 603 10 66	Illuminated door sills pebble beige/stainless steel with "AMG" writing	as required