Replace connector - AF91.40-P-8000-01A

Repairing wiring harness using solder connectors

AR00.19-P-0100-09A

Fig 1: Identifying Wiring Harness Repair Kit (220 589 01 99 00)

Frame floor system:

1. Carefully remove textile tape in area of connector.
2. Cut off cable directly at connector housing.
3. Remove approx. 15 mm of insulation from electrical leads.

   Do not strip insulation of the plastic-sheathed cable

4. Slide on solder connector.
5. Twist strands of two cable ends together.
6. Position solder connector in center and shrink (solder) with hot air blower.
7. Wrap textile tape around lead from connector up to over solder connector.
8. Slide new connector housing over gray clip part.