ETC control unit ME-SFI - fault code description - AD07.61-P-4000-29M
Transmission 722.6
| 1 | Fault code | P205E Internal fault (variant, memory, transfer) (P0702) |
| (Fault code according to OBD) | P2067 CAN message from electronic selector lever module control unit (N15/5) missing or faulty or selector lever module wrongly coded (P0705) P2068 CAN message: wheel speed at rear from ESP control unit missing or faulty (P0720) P20D5 The torque request from ETC [EGS] control unit is impossible (P0702) P20D6 CAN transmission error of torque request from ETC [EGS] control unit (P0702) P20D7 CAN transmission error of torque request from ETC [EGS] control unit (P0702) |
|
| 2 | Fault storage | After expiry of test duration and fault |
| Actuation of engine diagnosis indicator lamp (EURO4) or CHECK ENGINE (MIL) |
Following two successive driving cycles with faults | |
| 3 | Checking frequency | Continuous |
| 4 | Checked signal or status | Fault in ETC [EGS] control unit
|
| 5 | Faults are detected by the EGS control unit (N15/3) and reported via the CAN data bus to the ME-SFI [ME] control unit (N3/10). Fault storage and actuation of the CHECK ENGINE indicator lamp (MIL) take place via the ME-SFI [ME] control unit. Also read out the EGS fault memory. |