LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 2004 >> SL500 >> Repair and Diagnosis >> Engine Performance >> Tune-Up >> Fuel & Ignition -- Self-Diagnostic System -- 230 Chassis >> Self-Diagnostic System >> Gasoline injection and ignition system (ME-SFI) diagnosis - diagnostic trouble code memory - AD07.61-P-4000 >> ME-SFI fuel injection and ignition system (ME), DTC memory - AD07.61-P-4000M >> Air pump switchover valve - fault code description, ME-SFI - AD07.61-P-4000-78M

Air pump switchover valve - fault code description, ME-SFI - AD07.61-P-4000-78M

    Air pump switchover valve (Y32)
1A Fault code ME2.7.1 
(Fault code according to OBD)
P2024 (P0412)
1B Fault code ME2.7.2  P2024-(1) Short-circuit to positive (P0414)
  (Fault code according to OBD) P2024-(2) Short-circuit to ground (P0412)
P2024-(4) Line discontinuity (P0413)
2 Fault storage After expiry of test duration and fault
  Actuation of engine diagnosis indicator lamp (EURO4) or CHECK ENGINE (MIL) USA ONLY Following two successive driving cycles with faults
3 Checking frequency Continuous
4 Checked signal or status Current/voltage test on air pump switchover valve
5 Fault setting conditions   
  Short circuit to ground Voltage lower than 4 volts
  Short circuit to positive Current higher than 4.2 A
  Open circuit in wiring No voltage at charge air cooler circulation pump relay ca. 4 to 8 V on the under no load output of the ME control unit
7 IMPORTANT Actuation of the air pump switchover valve is checked for to detect a cable breakage and short-circuit (to ground or battery voltage). A short circuit to ground and a cable breakage will be recognized when the output stages are locked, while a short circuit to the battery voltage is recognized when the output stages are conducting.
The output stage is immediately no longer activated when a fault arises.