Remove/install rear door lining - AR72.12-P-1010MB

MODEL 220.1 /8 with CODE (Z07) Top protection 

Fig 1: Identifying Rear Door Lining Remove/Install Components

	Remove/install
1	Press trim strip (1) off of door control unit covering (2) using mounting wedge (8)		Figure
2	Unscrew bolts (15) and press out door control unit covering (2) from door lining (4)		Figure
3.1	Disconnect connector from left front door control unit (N69/3) or right front door control unit (N69/4) and remove door control unit covering (2)	Model 220.1
3.2	Disconnect connector from driver-side rear door control unit (N69/3) or passenger-side rear door control unit (N69/4) and remove door control unit covering (2)	Model 220.8
4	Remove door handle cover (3) from door handle
5	Remove cover (5) from door handle
6	Unscrew bolts (10, 11) from door handle
7	Detach cover (12) and unscrew bolt (13) underneath
8	Unscrew bolt (6) from lock cover plate (7) and remove lock cover plate (7)
9	Remove bolts (14)
10	Press door lining (4) off of inner door panel with mounting wedge (8) and move out upward	Move mounting wedge (8) directly to mounting clips (9), otherwise, the retainer tabs for the mounting clips (9) can tear out of the door lining (4).
			Figure
11	Unhook operating cable from inside door opener
12	Disconnect electrical connectors from door lining (4) and lay down door lining (4)
13	Check mounting clips (9)	Installation:  Remove mounting clips (9) remaining on inner door panel and install at corresponding points on door lining, replace damaged mounting clips (9).
14	Install in the reverse order

Fig 2: Identifying Mounting Wedge (110 589 03 59 00)