Removing and installing light module - AR54.25-P-3260N
MODEL 215
| Removing, installing | |||
| 1 | Connect quiescent current retention unit | AR54.10-P-1030-07I | |
| 2 | Disconnect ground cable from battery | AR54.10-P-0003I | |
| 3 | Turn exterior lamp switch onto low beam and pull 1 detent towards the driver (fog lamp switched on) | ||
| 4 | Push extractor hook (01) in area of low beam symbol (A) and side light symbol (B) between rotary light switch (1) and light module cover (2) | Fig 2 | |
| 5 | Turn extractor hook through 90° and pull out light module cover | ||
| 6 | Unscrew screws (3) | ||
| 7 | Press clips (4) and remove light module (N7-1) | ||
| 8 | Unlock coupling (5) and pull off | ||
| 9 | Install in reverse order | ||
| 10 | Carry out function check |