Remove/install center console - AR68.20-P-2000AM

MODEL 220.074 /174 

Fig 1: Identifying Center Console Remove/Install Components - Model 220.074/174

Fig 2: Identifying Center Console And Bolts

	Remove/install
1	Remove selector lever cover (8)	Position selector lever in position "D"	AR68.20-P-2310M
2	Connect quiescent current retention device		AR54.10-P-1030-07I
	Risk of explosion  from explosive gas. Risk of poisoning and caustic burns  from swallowing battery electrolyte. Risk of injury  through burns to skin and eyes from battery acid or when handling damaged lead-acid batteries	No fire, sparks, naked flames or smoking. Wear protective gloves, acid-resistant clothing and safety glasses. Pour battery electrolyte only into suitable and appropriately marked containers.	AS54.10-Z-0001-01A
3	Disconnect ground cable of battery	Turn key in electronic ignition switch EIS into position "0". Key cannot be withdrawn. Vehicle fitted with code (889) Keyless-Go: Switch off engine, remove Keyless Go cards from the vehicle and keep outside the range of the transmitter. Ensure that ground cable will not come into renewed contact with the battery terminal as you are working. Installation:  Read out fault memory after connecting, adjust time display on combination instrument, code radio, normalize power window and activate steering angle sensor. Vehicles with stationary heater: adjust time display on stationary heater.	AR54.10-P-0003I
	Notes on battery		AH54.10-P-0001-01A
4	Open stowage compartment lid (10) in front of selector lever, unclip floor (9) and take out
5	Unscrew screws (1)
6	Unscrew screw (2)	Move driver and front passenger seat to foremost position.
7	Unclip and remove top cover (5)
8	Disconnect connector of rear compartment nozzle adjustment illumination
9	Disconnect connector of stowage compartment illumination
10.1	Disconnect connector of telephone system	Only with code 316 MB telephone, D-network (D2B) in armrest. Only with code 317 Portable CTEL telephone, D-network (D2B) in armrest.
11	Disconnect TV connector in rear
12	Lift rear center console (3) and guide out of instrument panel	Keep lid (10) closed.
13	Install in the reverse order
14	Render electrical system operational	Perform basic programming (normalize windows and sliding roof, etc.).	AR00.19-P-0200M
15	Carry out function test