Installing two-way radio set holder in glove compartment - AN82.71-P-1000-05M

Model 220 

1. Unclip stowage shelf for mobile telephone from glove compartment (no longer required).
2. Clip new cover (13) into glove compartment cover.
   Fig 1: Identifying Cover

   
3. Position two-way radio set holder (14) on bottom of glove compartment as shown in figure and align. Mark hole pattern and drill with 6.5 mm dia. bit.
   Fig 2: Identifying Two-Way Radio Set Holder And Bracket

   
4. Mark line passage in glove compartment as shown in figure and cut out.
   Fig 3: Identifying Mark Line Passage In Glove Compartment

   
5. Screw two-way radio set holder (14) and bracket (15) into glove compartment with commercially available M6 screws and nuts.
   Fig 4: Identifying Two-Way Radio Set Holder And Bracket