Installing ID code wiring harness - AN82.71-P-1000-02M

Model 220 

Connection schematic for ID code wiring harness 

Fig 1: Identifying ID Code Lead

1. Route ID code wiring harness (5) as shown in figure from cockpit wiring harness/frame floor system connector (X18) in passenger footwell through right A-pillar and below instrument panel.
2. Route tie-out to distance sensor separation point (X104) as shown in figure below instrument panel and fasten with adhesive felt.
   Fig 2: Identifying ID Code Wiring Harness And Cockpit Wiring Harness/Frame Floor System Connector

   
3. Route tie-out from ID code wiring harness (5) as shown in figure in passenger footwell and connect cockpit wiring harness/frame floor system connector (X18) to frame floor system wiring harness (1).
   Fig 3: Identifying ID Code Wiring Harness And Frame Floor System Wiring Harness

   

   When installing transponder socket for distance sensor performs step 4 and  5

4. Mark hole pattern for distance sensor socket (6) as shown in figure in right knee guard and cut out to dia. 9 mm.
5. Install distance sensor socket (6) in right knee guard.

   When installing knee guard it is necessary to connect the distance sensor separation point (X104) and fasten the lead with adhesive felt.

   Fig 4: Identifying Sensor Socket And Hole