Retrofitting TV tuner - AN82.60-P-0001D: Notes
MODEL 215 up to 31.8.02 with CODE (352a) COMAND operating and display system except CODE (862) TV preinstallation
| Notes on COMAND software status | Models 215, 220 with CODE (352a) COMAND operating and display system with the 3rd generation of APS. | AH82.60-P-0001-01A | |
| Remove | |||
| 1 | Connect quiescent current retention device | *WH58.30-Z-1012-09A | |
| 2 | Disconnect ground cable of battery | ||
| AR54.10-P-0003I | |||
| 3 | Remove cover on center console | ||
| AR68.20-P-2350N | |||
| 4 | Remove front seat | ||
| AR91.10-P-1000N | |||
| 5 | Remove rear seat cushion | ||
| AR91.12-P-1020N | |||
| 6 | Remove rear backrest | ||
| 7 | Open left wiring ducts | ||
| 8 | Remove trim on left C-pillar | ||
| 9 | Lower headliner at rear | ||
| 10 | Remove antenna amplifier module |
||
| AR82.62-P-8300I | |||
| 11 | Remove coverings in trunk | ||
| Model 215.3. | AR68.30-P-4600M | ||
| Install | |||
| 12 | Install TV tuner (A2/42) in luggage compartment | AN82.60-P-0001-01C | |
| 13 | Retrofit wiring harness for TV tuner (1) | AN82.60-P-0001-03C | |
| 14 | Fit remaining parts to vehicle | ||
| 15.1 | Load software update for TV tuner (A2/42) | AN82.60-P-0001-02B | |
| 16 | Supplement special equipment on the vehicle data card and in the vehicle data card online |
COMMERCIALLY AVAILABLE TOOLS
| Number | Designation |
|---|---|
| WH58.30-Z-1012-09A | Quiescent current retention unit |
PARTS ORDERING NOTES
| Part no. | Designation | Quantity |
|---|---|---|
| KG82 (see EPC) | TV tuner | 1 |
| KG82 (see EPC) | Bracket | 1 |
| KG82 (see EPC) | Nut M5 (TV tuner to bracket) | 1 |
| KG82 (see EPC) | M5 x 12 screws | 2 |
| KG82 (see EPC) | TV tuner wiring harness | 1 |
| KG82 (see EPC) | Antenna module (order according to vehicle equipment) | 1 |
| KG82 (see EPC) | Collar nut | 1 |
| KG82 (see EPC) | Clip fastener | 2 |
| KG82 (see EPC) | Side paneling in trunk on left (order according to vehicle equipment) | 1 |