 |
Lethal injuries
are possible if vehicle slips off of lifting platform |
Align vehicle between the columns of the hydraulic hoist and position the four support plates below the hoist support points specified by the vehicle manufacturer. |
AS00.00-Z-0010-01A |
| 1 |
Pre-tension automatic cable slack adjuster |
|
AR42.20-P-0520-01A |
| 2 |
Remove cover of pedal assembly (71) |
|
|
| 3 |
Remove parking brake indicator switch (S12). |
|
|
| 4 |
Detach brake cable (85) from tensioning shackle at parking brake pedal (75) and unclip from holding lug using snap-release tool (043) |
 Installation:
Observe rubber ring (85c). |
|
| |
|
Snap-release tool |
Fig 2 |
| 5 |
Remove pedal assembly (71). |
Unscrew upper bolt (72) to do this. Only loosen lower bolt (72) and detach pedal assembly (71) |
|
| |
|
Do not
loosen torx bolts on back of pedal assembly (71) otherwise the pedal assembly (71) will be damaged beyond repair. |
|
| |
|
 |
*BA42.20-P-1001-01A |
 |
Friction brake of parking brake pedal assembly, function |
|
GF42.20-P-1000A |
| 6 |
Detach control cable (79) for releasing parking brake. |
To do so, first remove the bracket (77a) and then detach the control cable (79) from the release lever (77). Unclip control cable (79) from pedal assembly (71) using tool (010). |
|
 |
Tool for releasing parking brake control cable |
|
WF58.50-P-4220-01A |
| 7 |
Install in the reverse order |
|
|
| 8 |
Relieve load on automatic slack adjuster. |
|
AR42.20-P-0520-02A |
 |
Inspecting |
|
|
| 9 |
Check version of pedal assembly (71) |
|
|
 |
Parking brake pedal assembly modified |
|
BT42.20-P-0510-01A |
| 10 |
Adjust parking brake |
|
AR42.20-P-0540GH |