 |
Risk of poisoning
from swallowing brake fluid. Risk of injury
from skin and eye contact with brake fluid. |
Pour brake fluid only into suitable and appropriately marked containers. Wear protective clothing and eye protection when handling brake fluid. |
AS42.50-Z-0001-01A |
 |
Notes on brake fluid |
All models |
AH42.50-P-0001-01A |
|
Notes if loss of brake fluid is not visible externally |
Models 129, 140, 163, 168, 170, 202, 203, 208, 209, 210, 215, 220, 414, 460, 461, 463.200 /204 /206 /207 /208 /209 /220 /221 /224 /225 /227 /228 /230 /231 /232 /233 /240 /241 /244 /245 /247 /248 /249 /250 /254 /300 /304 /307 /308 /309 /320 /321 /322 /323 /324 /325 /327 /328/330/331 /332/333 |
AH42.10-P-9406-02A |
|
Notes on repairs to brake system |
All models |
AH42.00-P-0003-01A |
| 1 |
Open engine hood and raise to vertical position |
Up to VIN A145272, X708318 |
AR88.40-P-1000GH |
| |
|
As of VIN A145273, X708319 |
AR88.40-P-1000GI |
| 2.1 |
Remove engine cover |
Model 163.113/128. |
|
| 3 |
Unscrew pressure circuit brake line (DK) and secondary brake circuit brake line (SK) from tandem master brake cylinder (1). |
Risk of confusion!
Before unscrewing, mark the brake line in relation to the appropriate connection.
Plug connections with blind plugs to prevent brake fluid flowing out. |
|
| |
|
 |
*BA42.10-P-1003-04A |
| |
|
Box wrench bit |
Figure |
| |
|
Set of plugs |
Figure |
| 4 |
Unscrew pressure circuit brake line (DK) and secondary brake circuit brake line (SK) from traction system hydraulic unit (A7/3). |
Risk of confusion!
Before unscrewing, mark the brake line in relation to the appropriate connection.
Plug brake line and connections with blind plugs to prevent brake fluid flowing out.
Installation:
Observe markings when screwing on brake lines. Do not mix up brake lines. |
|
| |
|
|
*BA42.40-P-1001-01A |
| |
|
Box wrench bit |
Figure |
| |
|
Set of plugs |
Figure |
| 5 |
Unclip pressure circuit brake line (DK) and secondary brake circuit brake line (SK) from longitudinal frame member at inside |
Risk of damaging clips (2). |
|
| 6 |
Remove pressure circuit brake line (DK) and secondary brake circuit brake line (SK) |
Risk of confusion!
Label brake lines. |
|
| 7 |
Install in the reverse order |
|
|