Legend of wiring diagram of electronic transmission control (ETC) - PE27.19-P-2100-60A
TRANSMISSION 722.610 in MODEL 463 in ENGINE 112.945
TRANSMISSION 722.630 in MODEL 463 with ENGINE 113.962
| Item | Designation | Coordinate |
|---|---|---|
| B49 | Transmission output speed sensor | 15L |
| B49x1 | Transmission output speed sensor connector | 14H |
| E7 | Reverse lamp | 27E |
| F1 | Fuse box | 4F |
| 30F | ||
| F1f8 | Fuse 8 | 30F |
| F1f10 | Fuse 10 | 17L |
| 31F | ||
| F1f12 | Fuse 12 | 16L |
| F1f17 | Fuse 17 | 4F |
| G2 | Generator | 8L |
| K26 | Wiper system relay module | 29D |
| K38/3 | Starter lock-out relay module | 5D |
| K40 | AIR pump relay | 12L |
| K40k5 | Differential lock relay | 12K |
| M1 | Starter | 7L |
| M6/1 | Wiper motor | 30L |
| N3/10 | Engine control module (ME-SFI [ME]) | 2L |
| N15/3 | ETC control module | 3A |
| 13A | ||
| 23A | ||
| 32A | ||
| 41A | ||
| N36 | Transmission output speed sensor ballast | 15G |
| R2/3 | Right heated windshield washer nozzle | 31L |
| S2/1 | Ignition/starter switch | 17G |
| 31D | ||
| S4x1 | Combination switch connector | 28D |
| S9/1 | Stop lamp switch (4-pin) | 32K |
| S16/6 | Kickdown switch | 19L |
| S16/10 | Transmission range recognition switch (voltage coded) | 22L |
| S76 | Differential lock switch group | 11L |
| S76/10 | Road/neutral/off-road switch | 4L |
| U12 | Valid for LHS | 18K |
| 19D | ||
| 28J | ||
| 32L | ||
| U13 | Valid for right-hand steering | 18L |
| 19D | ||
| 28D | ||
| U13 | Valid for right-hand steering | 31L |
| U54 | Valid for towing hitch | 26D |
| U190 | Valid for engine APS | 25D |
| U241 | Valid for BA <RFH> | 28D |
| W12 | Ground (center console) | 23D |
| W29/1 | Ground, left A-pillar | 18K |
| W29/2 | Ground (right A-pillar) | 18K |
| 19D | ||
| W29/7 | Ground (steering column) | 19E |
| W30 | Ground (frame) | 27D |
| X4/30 | Terminal block (circuit 30, engine) | 7F |
| X6 | Terminal block (circuit 58) (2-pin) | 23D |
| X11/4 | Data link connector (DTC readout) | 13L |
| X12/3 | Terminal block (circuit 30, 15, 61 (3-pin) | 4D |
| 24D | ||
| X24/5 | APS/HLS connector | 25D |
| X26/26 | BA [RFH] connector | 27D |
| X35/63 | Control module box/engine separation point | 5H |
| X58 | Trailer hitch socket (13-pin) | 26D |
| X62/31 | Differential lock connector | 3J |
| X92/3 | Frame connector (22-pin) | 25G |
| Y3/6 | Valve unit (ETC [EGS]) | 38L |
| Y3/6b1 | Transmission oil temperature sensor | 40K |
| Y3/6n2 | RPM sensor 2 | 41K |
| Y3/6n3 | RPM sensor 3 | 40J |
| Y3/6s1 | Starter interlock contact | 40J |
| Y3/6y1 | Modulating pressure regulating solenoid valve | 37H |
| Y3/6y2 | Shift pressure regulating solenoid valve | 37J |
| Y3/6y3 | 1-2/4-5 shift solenoid valve | 37K |
| Y3/6y4 | 3-4 shift solenoid valve | 39K |
| Y3/6y5 | 2-3 shift solenoid valve | 39J |
| Y3/6y6 | Torque converter lockup PWM solenoid valve | 39H |
| Y66/1 | Reverse/parking lock valve | 10L |
| Z50/1 | Connector sleeve 1 | 31K |
| Z51/7 | CAN (High) 1 connector sleeve | 33L |
| Z51/8 | CAN (Low) 1 connector sleeve | 33L |
| Z51/9 | CAN (High) 2 connector sleeve | 33H |
| Z51/10 | CAN (Low) 2 connector sleeve | 32H |