Gap dimensions on hoods, doors and lids - AR60.00-P-0700-01CW

Shown on model 204.0 

Adjust hood, doors and lids as shown in drawings in magnifying glasses. The gap should not run wedge-shaped or be too narrow at points. Deviations from parallel gap should be max. 1 mm over the entire length. If the inside clearance is too large or too small, the movable body parts must be centered accordingly. The reference measurements apply only for repair work on vehicles damaged in accidents.

Front door to roof frame (dimension "I") is not a circumferential reference dimension, therefore it is necessary to maintain the approval position according to the drawing in magnifying glass.

Shown on model 204.0 

Rear door to roof frame (dimension "J") is not a circumferential reference dimension, therefore it is necessary to maintain the approval position according to the drawing in magnifying glass.

Shown on model 204.2 

Rear door to roof frame (dimension "J") is not a circumferential reference dimension, therefore it is necessary to maintain the approval position according to the drawing in magnifying glass.

Illustrated on model 204.3 

Adjust hood, doors and lids as shown in drawings. The gap should not run wedge-shaped or be too narrow at points. Deviations from parallel gap should be max. 1 mm over the entire length. If the inside clearance is too large or too small, the movable body parts must be centered accordingly. The reference measurements apply only for repair work on vehicles damaged in accidents.

Illustrated on model 204.3