Install paneling - AR77.20-P-0500-02EC

Fig 1: Identifying Paneling & Sliders

Courtesy of MERCEDES-BENZ USA

Position sliding element (2) horizontally at tilting brackets.
Open tilting/sliding roof.
Insert paneling (1) into roof cutout.
Push guide sleeve on rear section of paneling (1) onto guide pin on roof cutout.
Slide paneling (1) toward rear to stop.
Carefully push paneling (1), otherwise the side molding (3) in the sliders (2) can pinch and be damaged.
Clip paneling (1) into tilting/sliding roof panel.
Move tilting/sliding roof to half tilted position.
Carefully move tilting/sliding roof to tilted position, because, if the side moldings (3) are pinched, they could be damaged by tilting.

It should be possible to retract or extend the side moldings (3) without resistance.

Fig 2: Identifying Paneling, Sliders And Side Molding
Courtesy of MERCEDES-BENZ USA