Remove/install paneling on B-pillar - AR68.30-P-4700GN

MODEL 463.243 /245 /246 /248 /249 /323 /333 up to 31.5.04 wheelbase 2850 mm 

Fig 1: Identifying B-Pillar Paneling

Courtesy of MERCEDES-BENZ USA

Fig 2: Identifying Panel

Courtesy of MERCEDES-BENZ USA

Fig 3: Identifying Bolt On Belt End Fitting

Courtesy of MERCEDES-BENZ USA

Fig 4: Identifying Cover And Nut On Seat Belt Guide Bracket

Courtesy of MERCEDES-BENZ USA

	Remove/install
1	Remove rubber door seals (arrows) in area of B-pillar paneling (1)
2	Remove cover (2) and unscrew bolt on belt end fitting (3)		*BA91.40-P-1001-01C
			Fig 5
3	Remove cover (4) and unscrew nut on seat belt guide bracket (5)		*BA91.40-P-1002-01C
4	Pull belt out of B-pillar paneling (1)
5	Unplug connector from rear heated seat switch	Only with code H11.
6	Remove B-pillar paneling (1)
7	Install in the reverse order

Fig 5: Identifying Torx Bit Set (000 589 01 10 00)

Courtesy of MERCEDES-BENZ USA