Remove/install cable for engine hood - AR88.40-P-2629GR

MODEL 461.302 /304 /305 /331 /332 /333 /334 /340 /342 /343 /344 /345 /346 

MODEL 463.202 /222 /236 /237 /243 /244 /245 /246 /247 /248 /249 /250 /254 /270 /271 /303 /306 /309 /322 /323 /332 /333 /336 /340 /341 /346 

Fig 1: Identifying Release Lever, Screw & Cable

Courtesy of MERCEDES-BENZ USA

Illustrated on model 463.248 

	Remove/install
1	Open engine hood		AR88.40-P-1000GG
2	Remove engine hood catch	Model 461.302/ 304/ 305/ 331/ 332/ 333/ 334/ 340/ 342/ 343/ 344/ 345/ 346, 463.243/ 244/ 245/ 246/ 247/ 248/ 249/ 250/ 254/ 303/ 306/ 322/ 323/ 336/ 340/ 341/ 346 Model 463.202/ 222/ 236/ 237 as of model year 2010	AR88.40-P-3200GR
		Model 463.270/271/309/332/333/ Model 463.202/222/236/237 up to model year 2010	AR88.40-P-3200GM
3	Expose cable (3) on wheel well panel
4	Unhook cover below dashboard	Only on model 463.202/ 222/ 236/ 237/ 243/ 244/ 245/ 246/ 247/ 248/ 249/ 250/ 254/ 270/ 271/ 303/ 306/ 309/ 322/ 323/ 332/ 333/ 336/ 340/ 341/ 346 Do not separate any electrical connectors.	AR68.10-P-1500GM
5	Remove release lever (1)
6	Pull out cable (3) with release lever (1)	Installation:  Apply lubricant to rubber grommet.	*BR00.45-Z-1004-06A
7	Check whether rubber grommet is damaged, replace if necessary
8	Unhook cable (3) from release lever (1)
9	Install in the reverse order