Adjust sliding jaws on tilting/sliding roof - AR77.20-P-1100-01A
- Loosen screws (4) from slide angle on left and right.
- Align titling/sliding roof precisely in center of cutout.
- Move sliding angle to inside (arrow) until sliding jaws make contact with guide at side.
- Check centricity of titling/sliding roof in cutout.
- Tighten screws (4) on slide angle on left and right.
- Remove guide plate (1) from sliding carrier (2).
- Manually move titling/sliding roof cover and check side play of sliding jaws in relation to guide at several points.
Tilting/sliding roof panel should not cant, if necessary readjust sliding bracket, otherwise malfunctions can occur.
- Install guide plate (1) on sliding carrier (2).